PLEASE READ PRIOR TO INSTALLATION
- PLEASE READ PRIOR TO INSTALLATION
- Safety Information
- Unpacking
- Installation - Frame Fitting
- Installation - Fitting Mirror Module
- Installation - Fitting the Trim Ring
- Electrical Operation – Testing`
- Projector Installation
- DT-Actuator-Commander Software
- Mirror Setup
- Bottom Cover Installation
Before installation of this mount you should fully read these instructions to ensure you are aware of the full installation procedure.
In addition to the mount and accessories to carry out the installation you will need:
• Suitable screw fixing screws/fixings for fixing of the frame
• Spirit level
• Measuring tape
In the Installation accessories you will find:
• IEC Power cord of the relevant type for your location
• Allen keys
It is recommended that at least 2 people install this mount.
Due to the weight relevant Lifting equipment must always be used to support the mount and the weight of the projector during installation. Fully read the manual before commencing installation.
Important Notes
The symbols below show important notes that must be read and understood at each stage of the installation
Warnings (Safety or Installation Quality) = ⚠️
Information (Installation requirements or tips) =📄
From time to time we will release updated versions of manuals. To ensure that you always have the latest version always check against the relevant product on our website – www.displaytechnologies.co.uk
Any support questions can be sent to our support team – support@displaytechnologies.co.uk