Electrical Operation – Testing`

• PLEASE READ PRIOR TO INSTALLATION
• Safety Information
• Unpacking
• Installation - Frame Fitting
• Installation - Fitting Mirror Module
• Installation - Fitting the Trim Ring
• Electrical Operation – Testing`
• Projector Installation
• DT-Actuator-Commander Software
• Mirror Setup
• Bottom Cover Installation

⚠️ It is important to now test the operation of the mirror. THe easiest way to do this is to use the IR remote pointed at the IR receiver attached to the control box.

1. While the unit powered off - Plug the IR receiver from the acessories box into the 3,5mm IR port on the control box.

2. Plug in the power cord previously fed through the access hole in the top of the mirror module to the power supply.

3. Wait 30 seconds.

4. Press the FWD on the remote. The mirror flap will move down

5. Press the BACK on the keypad. The mirror flap will up

⚠️ If the unit is not powered off when the IR receiver is pluged in you will need to power cycle it for the IR to initiate and work.

⚠️ If the unit does not operate it may require ‘Homeing’ following shipping and installation. To do this simply hold down the 'Home' button for >5 seconds. Dependant on the location of the mirror you may see the mirror moving towards the fully closed position before stopping. Following this you will then be able to operate the mirror mechanism as above.